亚洲1卡二卡3卡4卡新区在线,亚洲AV成人无码网天堂,亚洲一区精品动态图成年视频,日韩国产中文字幕黄色,又爆又大又粗又硬又黄,一级a性色生活久久无码,亚洲中文字幕电影不卡电影

Shandong CNC machine tool repair and maintenance of CNC lathe

Machine commissioning
Machine tools in place, according to the customer designated location, location is good.
Machine mat MATS, machine tool to wipe clean, adjust good level.
To guide infuse relevant hydraulic oil tank, oil box, label the fuel and lubricating oil, water tank to machine tool with good cutting coolant.
According to the machine rated power, installed the corresponding power supply, and with good ground voltage stabilizer and machine tool.
Debugging good positive &negative for axle shaft of machine tool, check the switch button and function of the machine tool is normal.
Using the matters needing attention
Machine operators must be been properly trained and qualified personnel, machine operators when using the machine, be sure to see familiar machine operation manual and understand its contents before operating the machine.
Check whether to close the door tothe electric cabinet, adequacy of lubricant and coolant, machine tools and its surrounding should not have a foreign body, hamper the movement of machine tools.
Before operating the machine, please check the input data, to ensure that specified by the feed speed and want to machine operation, if you use the incorrect data, or not at the correct rate, machine misoperation may occur, causing the workpiece or damage to the machine itself or cause harm to the staff.
Parts processing before, must first check the normal operation of the machine tool, is not installed on the machine tool when the workpiece and tool check the correct operation of the machine tool.
When using the cutter compensation function, please carefully check the direction of compensation and compensation amount, using incorrect data operation of machine tools, machine tools may be false action, which can potentially cause artifacts or the machine itself and even cause personnel injury.
When the manual machine tools, to confirm the current location of the cutter and workpiece and ensure correctly specified the movement direction of the axis, and the feed speed.When the hand wheel feed in larger magnification rotate handwheel, knives and workbench will move rapidly, may produce the handwheel stop running, and the cutting tool and the phenomenon of the workbench will not immediately stop.Large ratio of the handwheel move is likely to cause tool or machine damage and even cause personnel injury.
Machine tool fault cannot be ruled out, if any, please contact the machine suppliers.
The machine maintenance
Regularly check whether the oil is enough, with or without line congestion, lubricating oil and cooling liquid pollution degree, whether to need to change.
Tool turret rotation whether smooth, tool install and remove the interference, point whether there is damage;Whether there is dirt inside the tailstock taper hole, the cone is damaged.
Regularly check whether the X, Z axis movement is smooth, regular cleaning the X, Z trip switch, so as not to have oil and water and dust, affect the use.
Regularly wipe the machine appearance, such as the operation panel, system displays;Regularly check the electrical cabinet and the outlet and inlet line of electrical cabinet to see if there is dust, it was clean.
Check electrical high voltage contained in the dish, servo unit, spindle unit to see if there is dust, have, in the case of a power outage or a vacuum cleaner to clean with brush.
Regular inspection to check whether there is sundry, spindle fan rotation, there are clear, so as not to affect the main shaft running.
Regularly check whether actions of inspection in high voltage relay tray are normal, replace if necessary.
If the battery alarm system, should be timely contact machine tool manufacturers, timely replacement.